Further cost reduction and miniaturization of electronic systems requires new concepts for highly efficient packaging of MEMS components like RF resonators or switches, quartz crystals, bolometers, BAWs etc. This paper describes suitable base technologies for the miniaturized, low-cost wafer level chip-scale packaging of such MEMS. The approaches are based on temporary handling and permanent bonding of cap structures using adhesives or solder onto passive or active silicon wafers which are populated with MEMS components or the MEMS wafer themselves.
Firstly, an overview of the possible packaging configurations based on different types of MEMS is discussed where TSV based and non-TSV based packaging solutions are distinguished in general.
The cap structure for the TSV based solution can have the same size as the MEMS carrying substrate, since the electrical contacts for the MEMS can be routed either thought the cap or base substrate. Thus, full format cap wafers can be used in a regular wafer to wafer bonding process to create the wafer level cavity packages.
However, if no TSVs are present in the cap or base substrate, the cap structure needs to be smaller than the base chip, so that electrical contacts outside the cap area can be accessed after the caps were bonded. Such a wafer level capping with caps smaller than the corresponding base chips can be obtained in two ways.
The first approach is based on fabrication and singulation of the caps followed by their temporary face up assembly in the desired pattern on a help wafer. In a subsequent wafer to wafer bonding sequence all caps are transferred onto the base wafer. Finally the help wafer is removed from the back side of the bonded caps. This approach of reconfigured wafer bonding is especially used for uniform cap patterns or, if MEMS have an own bond frame structure. In that case no additional cap is required, since the MEMS can act as their own cap.
The second approach is based on cap structure fabrication using a compound wafer stack consisting of two temporary bonded wafers. One wafer acts as carrier wafer whereas the other wafer is processed to form cap structures. Processes like thinning, silicon dry etching, deposition and structuring of polymer or metal bonding frames are performed to generate free-standing and face-up directed cap structures. The so created “cap donor wafer” is used in a wafer to wafer bonding process to bond all caps permanently to the corresponding MEMS base wafer. Finally, the temporary bonded carrier wafer is removed from the backside of the transferred caps. With that approach a fully custom specific and selective wafer level capping is possible featuring irregular cap patterns and locations on the MEMS base wafer. Examples like the selective capping process for RF MEMS switches are presented and discussed in detail.
All processes were performed at 200mm wafer level.
