Abstract
Replacing congenitally missing teeth can be challenging due to anatomical limitations. This retrospective radiographic study aimed to evaluate i) the dimensions of the alveolar ridge in congenitally missing maxillary lateral incisor sites and ii) whether straightforward implant placement and placement in a prosthetically ideal position was possible. CBCT images of the maxillary alveolar ridge were measured at 3, 8, and 13 mm from the planned crown margin in a labio-palatal and mesio-distal dimension. Virtual implant planning was completed in 3D planning software to evaluate whether the straightforward placement of a 3 mm wide and 10 mm long implant (with 1.5mm safety distance to neighboring teeth; 1mm bone wall on the buccal and palatal aspect of the implant) was possible in a prosthetically driven position. Twenty-three patients with 39 missing maxillary lateral incisors were analyzed. The mean (SD) of the alveolar ridge labio-palatal width was varying, 4.6 mm (1.3) at 3 mm, 5.6 mm (1.2) at 8 mm, and 7.8 mm (1.9) at 13 mm. Radiologically straightforward implant placement was possible in 56.4% (n=22) of the sites. In five sites (22.7%) where straightforward implant placement was possible, the implants could be planned in a prosthetically driven position. According to patient records, straightforward implant placement was performed in 33.3% (n=13) of the cases, five of them in prosthetically driven position. In congenitally missing maxillary lateral incisor sites, the alveolar ridge width is limited in the labio-palatal direction and might affect the possibility of straightforward and prosthetically driven implant placement.